Available Packaging and Coverage
2 L (0.2–0.3 L/m² per coat depending on the absorbency of the substrate)
5 L (0.2–0.3 L/m² per coat depending on the absorbency of the substrate)
Application
Antiseptic treatment "Bio Stop" TM "Bayris" is designed for mineral surfaces, including concrete, ceramic, clinker and silicate brick, cement, cement-lime and gypsum plasters, stone, asbestos cement and other mineral substrates. It disinfects surfaces and helps prevent the growth of algae, mould, mildew, blue stain fungi and other biological contamination before plastering and painting works. Thanks to its specially developed formula, the product provides long-lasting protection. It is especially recommended for use in damp areas such as kitchens, bathrooms, basements and poorly ventilated rooms. "Bio Stop" TM "Bayris" is suitable for both interior and exterior use.
Characteristics
"Bio Stop" TM "Bayris" antiseptic treatment is ready to use, has no strong odour and contains no chlorine or other toxic substances. It penetrates deeply into the substrate and helps prevent the development of bacteria, mould, mildew and blue stain fungi. The product offers long-term protection. After drying, it does not form a polymer film and does not affect the adhesion or absorbency of the substrate.
Surface Preparation
Surface preparation should be carried out in accordance with applicable construction standards. The substrate must be visually clean, dry and free from loose particles or peeling layers. If necessary, remove dirt, dust, grease, traces of biological contamination, residues of oil-based or lime paints and other contaminants.
Application Method
Apply the product at substrate and ambient temperatures between +5°C and +30°C, avoiding direct sunlight, and at relative humidity levels between 50% and 80%.
Do not dilute with water. Stir thoroughly before use. Apply evenly in 1–2 coats using a brush, roller, spray equipment or paintbrush. Clean tools with water immediately after use. Further finishing works may be carried out after 12–14 hours.
Attention! Any modification of the finished product composition, misuse of the product and/or failure to follow the manufacturer’s instructions may significantly affect its performance characteristics. Suitability of the product for specific materials and compatibility with other materials must be determined by the user through preliminary testing. The manufacturer shall not be held liable for direct or indirect damages resulting from improper use of the product, as all application conditions cannot be controlled.
Consumption
Approximate consumption: 0.2–0.3 L/m² per coat depending on the type and absorbency of the substrate, application method and tools used.
Safety Measures and Disposal
Avoid direct contact with skin and eyes. In case of contact, rinse thoroughly with plenty of water. Seek medical advice if necessary. Construction waste must not be disposed of with household waste. Dispose of packaging and liquid residues at authorised hazardous waste collection points in accordance with local regulations.
VOC Content
VOC content in "Bio Stop" TM "Bayris" complies with the requirements of VOC emission regulations for primers. Maximum permitted VOC content: 30 g/L. Actual VOC content in the ready-to-use product: no more than 2 g/L.
Antiseptic treatment for mineral surfaces that disinfects and helps prevent the growth of algae, mould, mildew, blue stain fungi and other biological contamination before plastering and painting works.
Packaging 2 L; 5 L
Coverage 200–300 ml/m² per coat
Drying time 12–24 hours
Number of coats Recommended: 1–2 coats
Colour Transparent finish after drying
